ar0320p3063co

Replace rear crankshaft radial sealing ring

Type ar · emne 03.20 · version 0100 · 2007-04-30

Gælder for: ENGINE 642 in MODEL 204

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 03 Drivværk › 03.20 Krumtapaksel — Serie 204

EinPAS 15 Motor › 15.15 forbrændingsmotor komplet/motorblok/krumtapdrev › 15.15.41 Krumtapaksel/svinghjul/medbringerskive — Serie 204

Gælder også for motorer/gearkasser: 642 ***

AR03.20-P-3063CO

Replace rear crankshaft radial sealing ring

25.4.07

ENGINE 642 in MODEL 204

Replace rear crankshaft radial sealing ring

P01.40-2162-11

2 End cover

3 Crankshaft radial sealing ring

Remove/install

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

1

Remove end cover (2)

Installation: The end cover (2) must be replaced as the crankshaft radial sealing ring (3) is vulcanized into the end cover (2) and otherwise leaks may occur.

AR01.40-P-8913CO

Installation: Instructions in notes on sealant application and on correct installation of the end cover (2) must be strictly observed. Environmental and engine damage can occur if there is wrong installation. See

Install rear crankshaft radial sealing ring

AR03.20-P-3063-01OM

2

Install in the reverse order

Henviste dokumenter