Removing and installing grooved ball bearing of crankshaft

Type ar · emne 03.20 · version 0103 · 1997-01-28

Gælder for: ENGINE 601.943, 602.980 in MODEL 901, 902, 903, 904 ENGINE 602.984 in MODEL 667, 668, 670 ENGINE 602.985 in MODEL 668, 670

Ikke tilgængelig på “da”; vises på Engelsk.

AR03.20-D-8400A

21.3.96

ENGINE 601.943, 602.980 in MODEL 901, 902, 903, 904

ENGINE 602.984 in MODEL 667, 668, 670

ENGINE 602.985 in MODEL 668, 670

D03.20-0006-06

1 Flywheel

1 Spacer ring

3 Grooved ball bearing

4 End ring

 	Removing, installing
1	Remove clutch		AR25.10-D-0050A
2	Remove grooved ball bearing (3) together with end ring (4)	 Installing: use a suitable drift to insert new grooved ball bearing until it makes contact at the spacer ring. In many cases, it is possible to insert the grooved ball bearing by hand. After this, use a suitable drift to insert new end ring as far as a stop.
			*000589333300
			*000589253300
3	Take out spacer ring (2)	 Inspect condition, replace if necessary
4	Install in the reverse order

000 589 25 33 00

000 589 33 33 00

Countersupport

Internal extractor