W01.20-1067-09
1 | Clamp | 4 | Heat shield | |
2 | Bracket | 5 | Cylinder head cover | |
3 | Air intake duct |
Danger ! | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure with the safety strut. | |
Danger ! | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
| Notes on tilting the cab | ||
| Notes on avoiding damage through contamination and foreign objects | ||
| Remove | ||
1 | Tilt cab | ||
2 | Remove clamp (1) from bracket (2) | ||
3 | Remove bracket (2) | ||
4 | Remove air intake duct (3) | ||
5 | Remove heat shield (4) | ||
6 | Check profiled seal of the cylinder head cover (5) for leakage | If no leakage is determined, the profiled seal of the cylinder head cover (5) can be reused. | |
7 | Remove cylinder head cover (5) | The screw/bolts for the cylinder head cover (5) are secured from falling out. | |
| Clean | ||
8 | Clean cylinder head cover (5) and rocker arm frame over the whole circumference and on its sealing surfaces | ||
| Install | ||
9 | Install new profiled seal in the cylinder head cover (5) | Only if the profiled seal of the cylinder head cover (5) is leaky. | |
10 | Install cylinder head cover (5) | Bolt tightening procedure for cylinder head cover | |
Pay attention to tightening procedure for screw/bolts. | |||
Bolt, cylinder head cover to rocker arm housing | |||
11 | Install heat shield (4) | ||
12 | Install air intake duct (3) | ||
13 | Install bracket (2) | ||
14 | Attach clamp (1) to bracket (2) | ||
15 | Carry out an engine test run | ||
16 | Stop engine and check area around the cylinder head cover (5) for leaktightness | Visual inspection. | |
17 | Tilt back cab |
Henviste dokumenter
- ah0000n500001h Oplysninger om forebyggelse af skader på grund af snavs og fremmedlegemer
- ah6080n000301a Oplysninger om tipning af førerhus
- ar0120w501403md
- as0000z000501a Fare for ulykke ved automatisk igangsætning når motoren kører. Fare for personskade på grund af knusning og forbrænding, hvis der arbejdes mens motoren startes eller kører
- as6080z000101a Fare for personskade ved fastklemning og knusning, når førerhuset tippes