AP82.10-B-8260H | Check and correct the adjustment of the headlamps | 12.02.16 |
Vehicle 979.0 with Body 979.811
B82.10-0039-01
B82.10-0040-01
Lighting system (lights change-over switch)
1 Off
2 Position lights, delineation and illumination panel lights
3 Position lights, delineation, illumination panel lights and headlights
Indicator lights, headlights high and low light change-over switch
4 Low light
5 High light
6 Headlights flashing
7 Right-turn lights
8 Left-turn lights
B82.10-0008-01
B82.10-0009-01
B82.10-0001-01
| Check | ||
| Headlights alignment should be executed with unloaded vehicle, in flat ground and with calibrated tires. | Tire inflation pressure table. | |
Alignment with optical aligner | |||
1 | Place aligner in front of headlight to be aligned and position it according to equipment manufacturer instructions. | ||
| The switch between main low and high headlights is done using combined switch, located in the steering column. | ||
2 | Turn on headlights in low light position activating light change-over switch in position (3) and (4). | Light-dark limit, to the left of central point, should be located on horizontal line; and to the right of central point, it should be deviated above. | |
If required, actuate in the headlight adjusting screw to correct alignment. | |||
3 | Turn on headlights in high light position activating light change-over switch in position (3) and (5). Light beam center should fall on central point (A) inside the frame limits. | For headlights with two filament lamps (high and low light), after low light is adjusted, high light adjustment should be automatically aligned, test only. If high light alignment is excessively incorrect, replace headlight lamp. Small high light divergences are tolerable. | |
For headlights with one-filament lamps (high light), correct the headlight alignment actuating in the adjusting screws |