W14.40-1617-09
1 | Pumps module | 5 | Filter Element | 9 | Sealing edge | ||
2 | Filter bowl | 6 | Freeze protection membrane | 10 | Slot of the splicing body | ||
3 | Pin | 7 | Sealing ring | 11 | Breather | ||
4 | Sealing ring | 8 | Housing filter |
| Remove | ||
Warning | Risk of burn injuries and scalding when working at AdBlue lines and the components attached to them. Risk of injury to skin and eyes when handling AdBlue. Risk of poisoning caused by swallowing AdBlue | Pour AdBlue into suitable containers only. Wait until the pressure is released before starting any work on the exhaust aftertreatment system. | |
Notes on use, material properties and handling of AdBlue® | |||
1 | Drain the AdBlue from the pump module (1) | Place an adequate container under the pump module (1) to drain the AdBlue. | |
2 | Remove filter bowl (8) | ||
3 | Remove the sealing ring (7) | ||
4 | Remove the freeze protection membrane (6) | ||
5 | Remove the filtering element (5) with the sealing ring (4) | Remove the filtering element (5) by turning it lightly. | |
| Install | ||
6 | Install the breather nipple (11) | Only if the breather nipple (11) is not already pre-assembled in the filter bowl (8). | |
For that, press the breather (11) inwards the filter bowl (8) in the hole provided for this, until an audible snap is perceived. | |||
7 | Install the filter element (5) | For that, fit the filtering element (5) with the sealing ring (4) through the pin (3) and press up to the backrest. | |
8 | Position the freeze protection membrane (6) through the filter element (5) over the filter bowl (2) | The groove in the filter bowl (2) should be free from dirt and stranger bodies. | |
The sealing edge (9) should fit correctly along the groove in the filter bowl (2). | |||
9 | Apply anti-friction product around the sealing edge (9) | Always use the prescribed spray as anti-friction product. | |
This prevent damages in the exhaust gas after-treatment system. | |||
Biolube L spray | |||
10 | Apply the anti-friction product in the thread of the filter bowl (2) | Always use the prescribed spray as anti-friction product. | |
Biolube L spray | |||
11 | Place the sealing ring (7) in the groove provided in the filter bowl (8) | The groove should be free from dirt and stranger bodies. | |
12 | Install the filter bowl (8) | Filter housing in the pump module | |
13 | Connect the diagnose equipment and reprogram the ACM control unit | Turn on the ignition and start the application. | |
Select the corresponding vehicle and start a quick test. |
Henviste dokumenter
- ah1440n000101a Oplysninger om anvendelse og håndtering af AdBlue samt dets stofegenskaber
- as1440z000101a Fare for forbrænding og skoldning ved arbejde på AdBlue-rør og dermed forbundne komponenter. Fare for personskade på hud og øjne ved håndtering af AdBlue. Fare for forgiftning ved indtagelse af AdBlue