ap4720t0783aa

Fuel prefilter with water separator - replacing filter element

Type ap · emne 47.20 · version 0101 · 2006-07-20

Gælder for: ENGINE 457.942 in MODELS NMB671.015 /020 /021 /030 /042 /332 /333

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 47 Brændstofsystem, energiforsyning drivline › 47.20 Brændstofpumpe, filter — Serie 671 (modeller 015, 020, 021, 030, 042, 332, 333)

EinPAS 16 Brændstof-/energiforsyning motor › 16.10 Brændstofforsyning › 16.10.41 filter/vandudskiller — Serie 671 (modeller 015, 020, 021, 030, 042, 332, 333)

Gælder også for motorer/gearkasser: 457 942

AP47.20-T-0783AA

Fuel prefilter with water separator - replacing filter element

18.7.06

ENGINE 457.942 in MODELS NMB671.015 /020 /021 /030 /042 /332 /333

Fuel prefilter with water separator - replacing filter element

T47.20-0019-02

The display shows the version with electrical connector on water separator

1 Drain plug

2 Water separator

3 Filter element

4 Electrical connector

Fuel prefilter with water separator - replacing filter element

T47.20-0046-02

The display shows the version without electrical connector on water separator

1 Drain plug

2 Water separator

3 Filter element

Danger!

Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel and risk of injury to eyes and skin caused by contact with fuel.

No fire, sparks, open flames or smoking.
Pour fuels only into suitable and appropriately marked containers.

Wear protective clothing when handling fuel.

AS47.00-Z-0001-01A

1

Open engine compartment flap

Installation: Do not close engine compartment flap yet.

2

Shut off fuel feed

To do this, close the shutoff valve if fitted. If no shutoff valve is fitted ensure that no fuel dribbles out.

3

Drain fuel at the drain screw (1)

Use a suitable receptacle. Dispose of the fuel collected in an environmentally friendly manner.

4

Disconnect electrical connector (4)

Only carry out on version with electrical connector (4) on water separator (2).

5

Detach the water separator (2)

Installation: Clean the inside of the water separator (2), replace if damaged.

6

Detach filter element (3)

Installation: Oil the gasket, tighten the filter element (3) by hand.

*WH58.30-Z-1075-06A

7

Install in the reverse order

8

Bleed fuel system

AP47.00-T-1720-01AA

Checking

Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running

Secure vehicle to prevent it from moving by itself.
Wear closed and snug-fitting work clothes.
Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

9

Start engine and inspect fuel system for leaks

If the engine does not start after 30 s, repeat the starting procedure after 1 min.

10

Turn off engine

11

Close engine compartment flap

Commercially available tools

Number

Designation

WH58.30-Z-1075-06A

Offset screwdriver

Henviste dokumenter