ap4720b0780gas

Replace fuel filter

Type ap · emne 47.20 · version 0102 · 2018-04-13

Gælder for: Engine 350.905 in model 382.1

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 47 Brændstofsystem, energiforsyning drivline › 47.20 Brændstofpumpe, filter — Serie 350 (modeller 905) · Serie 382 (modeller 1**)

EinPAS 16 Brændstof-/energiforsyning motor › 16.10 Brændstofforsyning › 16.10.41 filter/vandudskiller — Serie 350 (modeller 905) · Serie 382 (modeller 1**)

AP47.20-B-0780GAS

Replace fuel filter

09.04.2018

Engine

350.905 in model 382.1

Replace fuel filter

B47.20-0010-07

A

Open

2

Fuel filter

B

Closed

3

Drain valve

1

Primary valve

4

Filter wrench

Remove

Danger

Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel.

No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only.
Wear protective clothing when handling fuel.

AS47.00-Z-0001-01A

1

Turn off ignition and remove the key

2

Turn-off the master switch

3

Rotate the lever of the main valve (1) up to the position B (closed)

A - Open
B - Closed

4

Open the gas drain slowly and evacuate the gas remaining in the system

5

Actuate the drain valve (3) to drain the oil from the fuel filter (2)

The access to perform maintenance works and repairs vary according to the type / body manufacturer. Refer to the body builder instructions

6

Remove the fuel filter (2)

Use a filter wrench.

Install

7

Install a new fuel filter (2)

The excessive mechanical tightening can twist the thread, as well damaging the filtering element sealing or the filter housing.

Do not perform the previous filling of the fuel filter.

Tighten it until the gasket touches the filter head surface. After, tighten more 3/4 of turn.

8

Rotate the lever of the main valve (1) up to the position (A) open

Open the valve slowly to avoid freezing.

9

Check for leakages by using a water and soap solution

If there are leakages, close the main valve (1), switch off the ignition switch (OFF) and immediately repair any leakage.

Henviste dokumenter