Rear axle - setting adjustment screw with sliding block
Type ap · emne 35.30 · version 0500 · 2019-02-13
Gælder for: Rear axle 741.93 in model 958.264 Rear axle 741.95 in model 958.1 Rear axle 745.09 in model 958.0/1 Rear axle 746.98/99 in model 958.0/1 Rear axle 772.112 in model 958.074/154 Rear axle 772.115/116 in model 958.1
Gælder også for motorer/gearkasser: 741 93*, 741 95*, 745 09*, 746 98*, 746 99*, 772 112, 772 115, 772 116
AP35.30-B-3560TG
Rear axle - setting adjustment screw with sliding block
01.02.2019
Rear axle
741.93 in model 958.264
Rear axle
741.95 in model 958.1
Rear axle
745.09 in model 958.0/1
Rear axle
746.98/99 in model 958.0/1
Rear axle
772.112 in model 958.074/154
Rear axle
772.115/116 in model 958.1
Modification notes
14.01.2019
Lock nut on adjustment bolt
BA35.30-B-1004-05B
1
Set screw
2
Locknut
3
Sliding piece
N35.00-0279-01
N35.00-0280-01
1
Unfasten the cotter nut (2)
Hold the adjustment bolts (1) with the help of an appropriate tool.
2
Screw the adjustment screw (1) until the sliding piece (3) touches the crown's edge
In this operation, hold the cotter nut (2).
The moment in which the sliding piece touches the crown is noticeable due to the increase of the resistance you feel when turning the adjustment bolt.
3
Adjust the play unscrewing the adjustment bolt (1)
Unscrew the adjustment bolt (1) in the axle: 741.93 at 90° 741.09 at 45° 741.98 at 60° 741.99 at 90° 772.112 at 90° 772.115/116 at 90°
4
Tighten the cotter nut (2) up to the prescribed torque
Ensure that the adjustment screw (1) does not move out of the previously adjusted position.
Rear axle 746.99 in model 958Locknut on adjustment bolt
