P77.50-2175-04
Shown on right side of vehicle
1 Outer A-pillar paneling
2 Blind rivet nut
P77.50-2179-01
1 Outer A-pillar paneling
8 Longitudinal marking
| On vehicles up to VIN 009766 SI65.00-P-0001V Observe and perform | ||
| There are two variously long outer A-pillar panelings (1) due to production tolerances. Both lengths are included in each installation kitFirst determine length required for outer A-pillar paneling (1) The two remaining outer A-pillar panelings (1) are not required | ||
1 | Completely open Vario roof with Vario roof actuation switch | Actuate Vario roof, see operating instructions | |
2 | Press upper rubber cover on outer A-pillar paneling (1) to side and read off longitudinal marking (8) | Meaning of longitudinal marking (8): "K" = short "L" = long | |
3 | Paint determined outer A-pillar paneling (1) to match color of the vehicle | ||
| Remove | ||
4 | Remove outer A-pillar paneling (1) | Always replace all clips | |
| |||
5 | Remove trunk lid seal | ||
| |||
| Install | ||
6 | Retrofit A-pillar roof rack mounting | ||
7 | Install new outer A-pillar paneling (1) | ||
| |||
8 | Install rear roof rack mounting | ||
Adjustment value for jigging blind rivet nut for roof rack mounting | |||
FireBird® blind rivet tool | |||
9 | Install new trunk lid seal | ||
| |||
10 | Enter special equipment in the vehicle data card and in the vehicle's online data card | Code (726) Roof rack mounting |
Adjustment value
Number | Designation | Model 171.4 | ||
BE65.00-P-1001-01A | Adjustment value for jigging blind rivet nut for roof rack mounting | mm | 3.5 (+0.1) | |
Workshop equipment
WE58.40-Z-1003-14A | Blind rivet tool |
Parts ordering notes
Part no. | Designation | Quantity |
Design group 99 (see EPC) | Roof rack mounting | 1 |