ad0761p600109d

Crankshaft position sensor - Check electrics - ME-SFI ignition system

Type ad · emne 07.61 · version 0104 · 2003-06-10

Gælder for: ENGINES 111.921 /942 as of 1.9.98, 111.943, 111.944 as of 1.8.96, 111.946 as of 1.6.98, 111.947 /973, 111.975 as of 1.8.96 ENGINE 111.945 in MODELS 208.335 /435 as of 1.6.98, 202.020 /080 as of 1.9.98 ENGINE 111.974 with CODE (494a) USA version with CODE (807) Model year 1997 with CODE (808) Model year 1998

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 07 Blandingstilberedning › 07.61 Benzinindsprøjtnings- og tændingssystem ME — Serie 202 (modeller 020, 080) · Serie 208 (modeller 335, 435)

EinPAS 15 Motor › 15.45 Motorstyring › 15.45.1 Grundinformation — Serie 202 (modeller 020, 080) · Serie 208 (modeller 335, 435)

Gælder også for motorer/gearkasser: 111 921, 111 942, 111 943, 111 944, 111 945, 111 946, 111 947, 111 973, 111 974, 111 975

AD07.61-P-6001-09D

Crankshaft position sensor - Check electrics - ME-SFI ignition system

Scope of test

Tester/test connection

Operation/

Prerequisite:

Specified value

Possible cause/

Remedy

1.0

Crankshaft position sensor (L5)

Signal

Voltage

93

(37E)

93

(37E)

N3/10

N3/10

94

(38E)

94

(38E)

Test using oscilloscope

Starter: operate

Engine: Idle speed

Only perform test with multimeter if oscilloscope is not available.

Starter: operate:

Engine: Idle speed

For signal, refer to

AD07.61-P-2000-07E

> 2.5 V

> 5 V

Increasing speed, increasing voltage

1.1

Teeth on drive plate

1.1

L5 resistance

93

(37E)

N3/10

94

(38E)

Ignition: OFF:

Remove connector E from ME-SFI control module (N3/10)

(at 20 °C)

600 - 1200 Ω

Cable

L5

Henviste dokumenter