Change software release in the engine management control unit (MCM)

SM07.15-W-0009B

Change software release in the engine management control unit (MCM)

13.05.2013

ENGINE

470.9 in MODEL 963, 964

Code: MCM FLASH

ENGINE

471.9 in MODEL 963, 964

Code: MCM FLASH

Operation no. of the operation texts or standard texts and flat rates

Category

Op. no.

Operation text

Time

Acc. no.

Code

N

028330

Change software release in engine management (MCM) control unit

0,7 h

07 975 53

MCM-FLASH

Change software release

1

Connect diagnostic system, start XENTRY and switch on ignition

 For the updating procedure to be performed, the following version must be installed on the diagnostic system:
 Version 03/2013 with add-on 2755. As of version 05/2013, the flashware is contained in the regular release.

2

Perform quick test

 The quick test is stored at the end of the diagnosis session as the initial quick test and can be printed out.

3

Change software release in engine management (MCM) control unit

 To do so, select following menu items:
 "MCM - engine management (A4)"
 "Adaptations"
 "Initial startup"
 "Control unit programming"

4

Delete fault memory in all control units

 If necessary, process the existing fault code, subject to a separate repair order.

5

Perform quick test, print out initial quick test and final quick test

 No fault codes should be present in the control units.

6

End XENTRY and disconnect diagnostic system