GF07.13-P-3102H | DFI control module location/task/function | 11.6.96 |
ENGINE 604.910 in MODEL 202.121 to 31.7.96
ENGINE 604.912 in MODEL 210.004 to 31.5.96
P07.13-0269-79
Input signals from:
B11/4 Coolant temperature sensor
B17 Intake air temperature sensor
B28 IFI/DFI [ERE/EVE] pressure sensor
K1 Overvoltage protection relay (Model 202)
K40 Relay module (210)
L5/6 Crankshaft position sensor (IFI/DFI [ERE/EVE])
S40 CC [TPM] switch
S40/3 Clutch pedal switch (only MT) starting with DAS II
Y23/2 Distributor pump
Y23/2b1 Fuel temperature sensor
Y23/2I2 Distributor shaft position sensor
Y23/2I1 Cam ring position sensor
N30 Vehicle speed signal from ABS control module (N30)
N47-2 Vehicle speed signal from ETS control module (Model 210)
N54 RCL [IFZ] control module
(Vehicles with DAS II only)
R25/2 IFI/DFI [ERE/EVE] accelerator pedal position sensor
S9/1 Stop lamp switch
S16/1 Starter lock-out/backup lamp switch (only AT)
P07.13-0270-79
Output signals to:
A1e34 EDC MIL
(Electronic Diesel Control)
K1 Overvoltage protection relay (Model 202)
K40 Relay module (Model 210)
N15 Kickdown cut-out relay module
(from 12/94)
N22 Automatic air conditioning pushbutton control module
Y23/2y3 Adjusting valve (start delivery control)
Y23/2y4 Supply valve (injection quantity control)
Y27 EGR [ARF] switchover valve
Y31/2 Pressure control flap vacuum transducer
X11/4 Datalink connector, 38-pin
Engine speed (TN signal)
N54 RCL [IFZ] control module (Vehicles with DAS II only)
Y3/4 Modulator pressure switchover valve (AT / CC)
Y3/5 Upshift delay switchover valve (AT / CC)
Y23/2 Distributor pump (DFI [EVE])
Y23/2y1 Shut-off valve (stop)
Y23/2y2 Check valve (injection quantity control)
DFI [EVE] control module task | To control the operation of the following systems and functions in response to input signals: Start quantity control Quantity control Start delivery control Emission control system Cruise control (only AT) Modulator pressure switchover (AT / CC) Upshift delay (AT / CC) A/C compressor shut-off | ||
To monitor inputs and outputs, test plausibility and record faults in memory To generate substitute values in the event of signal failure (limp-home mode) To perform diagnosis (output of faults stored in memory) | |||
DFI [EVE] control module function | The DFI [EVE] control module (N3/8) is supplied with voltage from the overvoltage protection relay (K1) or the relay module (K40) (circuit 87 unfused). It detects the input signals and actuates the outputs in line with current operating conditions | ||
Notes on DFI [EVE] fault memory | Engine 604.910 to 11/94 | ||
Engine 604.910 as of 12/94, Engine 604.912 | |||
DFI [EVE] diagnosis/fault storage function |