az8370d000204c

Routing wiring harness and connecting

Typ az · téma 83.70 · verze 0100 · 1998-05-15

Platí pro: MODEL 901.32, 902.32 /42, 903.32 /42, 904.32 /42

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 3 Nástavba › 83 Klimatizace › 83.70 Nezávislé topení, přídavné topení, přihřívač — Řada 901 (modely 32*) · Řada 902 (modely 32*, 42*) · Řada 903 (modely 32*, 42*) · Řada 904 (modely 32*, 42*)

EinPAS 39 Topení/větrání/chlazení › 39.25 Nezávislé topení/přídavné topení › 39.25.3 Dodatečná montáž/přemontování — Řada 901 (modely 32*) · Řada 902 (modely 32*, 42*) · Řada 903 (modely 32*, 42*) · Řada 904 (modely 32*, 42*)

AZ83.70-D-0002-04C

Routing wiring harness and connecting

Models 901.32, 902.32/42, 903.32/42, 904.32/42

Routing wiring harness and connecting

D83.70-0162-05

Survey, wiring harness for air heater

1 Wire, rd (c. 30)
2 Auxiliary fuse box
3 Wire, br (ground)

4 Wire, vi

5 Wire, gr

6 Wire gn/wt

7 Connector, 8-pin for heater

8 Connector, 6-pin for heater

9 Rubber grommet

10 Connector, 4-pin for control unit

Tie wires and wiring harnesses to present wiring harnesses with cable straps when routing. Avoid chafing points, attach chafe guard if necessary. Cut off or tie back excessively long wires or wiring harnesses. The vi, gr and gn/wt wires (4, 5 and 6) are not required for installation.

1 Connect power supply:

Remove auxiliary fuse box (2) from wiring harness and connect rd wire (1) to free fuse location on access cover on seat frame using flat spring contact. Connect fuse location to a fuse location connected to c. 30. Use 2 mm² wire and flat spring contact for connecting.

Insert 15 A fuse into fuse box.

If no free fuse location is present, leave auxiliary fuse box (2) on wiring harness and connect fuse box to c. 30.

Connect br wire (3) to central ground connection point on floor of seat frame.

Insulate and tie back vi and gr wires (4 and 5).

-----------------------------------------------------------------------------------------

2 Route wiring harness:

Route wiring harness with 8-pin and 6-pin connectors
(7 and 8) from driver's seat frame below floor covering to installation location for heater. Wiring harness should exit between cab side wall and floor covering.

Route wiring harness with 4-pin connector (10) from driver's seat frame below floor covering toward front to driver's footwell.

-----------------------------------------------------------------------------------------

Routing wiring harness and connecting

D83.70-0163-01

3 Connect heater:

Remove control module cover (11) from heater.

Lift control module cover at side with blunt blade (11).

Connect 8-pin and 6-pin connectors (7 and 8) to heater control module and insert rubber grommet (9) into cable passage in cover for sealing.

Reattach control module cover (11).