When a FleetBoard® control unit is retrofitted, the telematics must be enabled with the diagnostic system. To this end, the menu specified items in the chronologically listed systems must be selected and the changes that are described must be carried out.
1 | Connect diagnostic system. |
2 | Start "XENTRY". |
3 | Select brand selection "Mercedes-Benz". |
4 | Select category selection "Truck". |
5 | Select "Automatic vehicle definition". |
6 | Select "Diagnosis application". |
7 | Select system recognition. |
8 | Select menu item "Control unit direct entry". |
9 | Select CGW (A2) central gateway. |
Menu item "Adaptations"
"Parameterization" menu item
Menu item "02 Vehicle configuration"
Select parameter "541 Telematics platform" and change to value "FleetBoard"
Choose "Accept changes"
Follow the system's instructions
Menu item "01 Control unit list"
Change parameter "43 FleetBoard" to "Installed"
Choose "Accept changes"
Exit control unit "CGW (A2) central gateway"
Follow the system's instructions
10 | Select TCO (P1) tachograph. |
Menu item "Adaptations"
Select "Parameterization"
Change parameter "Telematics CAN bus" to "High-speed CAN bus"
The parameter "Telematics CAN bus" in the component "TCO (P1) tachograph" can only be changed with an inserted and valid workshop card. Performance of a tachograph check is not necessary.
Choose "Accept changes"
Follow the system's instructions
11 | End procedure and remove diagnostic system. |