Retrofit connecting cable of Communication and Navigation System (CNS) · az8285p000803mcd · Mercedes-Benz WIS

AZ82.85-P-0008-03MCD

Retrofit connecting cable of Communication and Navigation System (CNS)

Model	451.3/4 as of 8/31/10
	with code 516 (RADIO WITH USB INTERFACE)
	except code 460 (Canada version)
	except code 494 (US version)
	except code 498 (Japanese version)
	except code 737L (Mexico)
	except code 830 (China version)
	except code C08 (Basic fittings f. radio)
	except code P02 (car2go)
Model	451.3/4 as of 8/31/10
	with code 527 (High-Line radio)
	except code 460 (Canada version)
	except code 494 (US version)
	except code 498 (Japanese version)
	except code 737L (Mexico)
	except code 830 (China version)
	except code C08 (Basic fittings f. radio)
	except code P02 (car2go)

1	Mark bores on cover (5).

 The bores are to be made on the center axle, i.e., the distances (a) to the center of the bore must be identical.
The outside diameter of the bore must be flush with the shackles (5.1).

2	Drill bores to a Ø 4 mm in the cover (5).

3	Remove side bars by cutting them along the broken lines.

 The cut must be made accurately and carefully.
Otherwise, visual impairments may occur on the visible side of the cover (5).

P82.89-2484-11

4	Insert the connecting cables (3) into the side cutouts of the cover (5).

 The connecting cables (3) are to be inserted so that the USB connectors (3.2) are on the visible side of the cover (5).

 Dimensions:
Distance (b) of USB connectors (3.2) to cover (5) = 200 mm.

5	Fasten connecting cables (3) using a cable tie (6) to rear side of cover (5).

6	Mark the connecting cables (3) just behind the USB connectors (3.2) by attaching the adhesive labels (7) included.

 The adhesive labels (7) cannot be swapped, as the port assignment is not defined until the Communication and Navigation System (CNS) is connected.

7	Make adhesive labels (8), label with Port 1 and Port 2 then attach in accordance with the previously-fitted adhesive labels (7) onto the connecting cables (3) just behind the USB connectors (3.1).

P82.89-2485-10

 The following operation steps describe installation in a left-hand drive vehicle with glove compartment. With right-hand drive vehicles these operation steps must be carried out mirror-inverted.

8	Route USB connector (3.1) with connecting cables (3) through the side opening of the glove compartment to the device installation frame.

9	Insert cover (5) into opening of glove compartment.

10	Strap down excess line lengths of connecting cables (3).

 The USB plugs (3.1) are connected at a later stage to the Communication and Navigation System (CNS).

P82.89-2486-11