Retrofit Sound 30 APS navigation system

AZ82.61-D-0003A

17.11.99

MODEL 901, 902, 903, 904, 905

D82.61-1104-06

1 GPS antenna

A9 Radio and navigation operating unit

	Remove
1	Disconnect battery ground cable
2.1	Remove radio
2.2	Remove cover from radio installation shaft	 Vehicles without radio
3	Remove instrument cluster paneling.
		Model 901.0/3/4, 902.0/3/4, 903.0/3/4, 904.0/3/4	AR68.10-D-3511A
		Models 901.6, 902.6, 903.6, 904.6, 905.6	AR68.10-D-1550A
4	Remove instrument cluster	 Loosen instrument cluster only, do not disconnect connector.
		Model 901.0/3/4, 902.0/3/4, 903.0/3/4, 904.0/3/4.	AR54.30-D-6015A
		Models 901.6, 902.6, 903.6, 904.6, 905.6.	AR54.30-D-6015C
5	Remove paneling from A-pillar on driver's side
6	Loosen headliner in area of driver's seat above windshield
	Install
7.1	Install radio preequipment	 Only if radio, radio antenna and loudspeakers are not present.
8	Preparing vehicle electrical system for retrofitting navigation system	Model 901.0/3/4, 902.0/3/4, 903.0/3/4 and 904.0/3/4	AZ82.61-D-0003-01B
		Models 901.6, 902.6, 903.6, 904.6. 905.6	AZ82.61-D-0003-01C
9	Retrofit GPS antenna		AZ82.61-D-0003-02A
10	Install remaining parts onto vehicle
11	Fit radio and navigation control unit into radio installation shaft	 If necessary remove stays in area of installation shaft obstructing the installation.
12	Connect radio connector, radio antenna and GPS antenna to radio and navigation control unit and install control unit.
13	Carry out startup and function test		AZ82.61-S-0001-04S

Parts ordering notes

Part no.	Designation	Quantity
B6 656 01 80	Sound 30 APS navigation unit	1
B6 656 01 83	Installation kit for Sound 30 APS	1
A 001 543 01 15	Pulse distributor (only model 901.0/3/4, 902.0/3/4, 903.0/3/4, 904.0/3/4)	1
A 638 545 00 28	Base for pulse distributor (only model 901.0/3/4, 902.0/3/4, 903.0/3/4, 904.0/3/4)	1
A 002 546 74 40	Cutting clamp for wire cross section 0.35 to 0.75 mm2 (only model 901.6, 902.6, 903.6, 904.6, 905.6)	1