Retrofit holder for CA module card reader

AZ82.60-P-0032-02ECA

Retrofit holder for CA module card reader

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Model

207.3

with code U77 (Diesel Emission control BLUETEC (SCR))

1

Mask off area for mounting bracket for CA module card reader on trunk recess trim (2) with adhesive tape.

2

Mark hole (arrow A).

 Dimensions:
a = 80 mm
b = 60 mm

3

Position velcro strip (3) on previously marked hole (arrow A), align and mark remaining holes according to velcro strip (3).

 Velcro strip (3) must be aligned at a right angle to reference edge (arrow B).

4

Remove velcro strip (3).

5

Drill marked holes with dia. 6 mm.

6

Fasten velcro strip (3) with expansion rivets (4) on trunk recess trim (2).

 Use expansion rivets (4) with dia. 6 mm. Expansion rivets (4) are included in scope of delivery.

7

Fasten CA module card reader (1) to trunk recess trim (2) by means of velcro strip (3).

8

Mark hole (arrow C) for electrical wiring harness passage for CA module card reader (1).

9

Remove CA module card reader (1).

10

Drill marked hole (arrow C) with dia. 6 mm.

11

Cut in hole (arrow C) approx. 4 mm at four points (dashed lines).