Retrofit holder for CA module card reader

AZ82.60-P-0032-02EA

Retrofit holder for CA module card reader

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Model

207.4

1

Mask area for attachment of CA module card reader bracket to trunk recess paneling (2) with Velcro strip.

2

Mark hole (arrow A).

 Dimensions:
a = 90 mm
b = 95 mm

3

Place Velcro strip (3) at previously marked hole (arrow A), align and mark remainder of holes in line with the strip (3).

 The Velcro strip (3) must be aligned at a right angle to the reference edge (arrow B).

4

Remove Velcro strip (3).

5

Drill marked holes with 6 mm Ø.

6

Affix Velcro strip (3) with the expansion rivets (4) to the trunk recess paneling (2).

 Use expansion rivets (4) with a Ø of 6 mm. The expansion rivets (4) are included in the scope of delivery.

7

Affix CA module card reader (1) to trunk recess paneling (2) using Velcro strips (3).

8

Mark hole (arrow C) for guiding electrical wiring harness for CA module card reader (1).

9

Remove CA module card reader (1).

10

Drill marked hole (arrow C) with 6 mm Ø.

11

Cut into hole (arrow C), approx. 4 mm, four times (broken lines).