P91.18-0278-09
1 Rear seat backrest
2 Cover
3 Covering
4 Foil
9 Clips for longitudinal retention
10 Retaining wire
11 Clips for lateral retention
5 Screw
6 Rear armrest
7 Rear backrest frame
8 Foam rubber pad
P91.18-0279-06
2 Cover
8 Clips for longitudinal retention
10 Longitudinal retaining wire
11 Clips for lateral retention
12 Lateral retaining strip
13 Assembly hook
| Removal, installation | ||
1 | Remove rear seat and rear seat backrest | ||
2 | Place rear backrest (1) down on suitable surface with cover pointing downward | ||
3 | Unclip covering (3) and remove | ||
4 | Unhook foil (4) and remove | ||
5 | Unscrew screws (5, 4 each) and remove rear armrest (6) | ||
6 | Unhook cover (2) all the way around on the rear backrest frame (7) | ||
7 | Draw cover (2) over foam rubber pad (8) and rear backrest frame (7) at bottom and sides | ||
8 | Unhook clips (9) for longitudinal retention by turning clips (9, 16 each) 90° | Installation: Align clips (9) and connect with retaining wire (10) | |
| Installation tool for retaining wire | ||
9 | Unhook clips (11, 4 each) on lateral retaining strip (12) | ||
| Assembly hook for tacking tool | ||
10 | Remove cover (2) from foam rubber pad (8) | Installation: Fold in cover at side and align on foam rubber pad (8) with lateral and longitudinal retainers | |
| Upholstery filling of seat modified | Installation: Valid only when installing new seat covers or new rubberized fiber matting | |
11 | Pull retaining wires (10, 4 each) out of textile sleeves | Installation: Insert retaining wires and align | |
12 | Reinstall in opposite order |