P91.18-0268-09
1 Rear seat cushion
2 Cover
3 Cushion frame
7 Rubberized fiber matting
8 Upholstery clips for longitudinal retaining wire
9 Longitudinal retaining wire
4 Retaining clip
5 Foam rubber pad
6 Upholstery clip
1 Fondsitzkissen
P91.18-0269-06
2 Cover
5 Foam rubber pad
6 Upholstery clip for lateral retaining strip
7 Rubberized fiber matting
8 Upholstery clips for longitudinal retaining wire
9 Longitudinal retaining wire
10 Lateral retaining strip
11 Velcro strips
| Removal, installation | ||
1 | Rear seat cushion removed | ||
2 | Lay rear seat cushion (1) down on suitable surface with cover pointing downward | ||
3 | Press cushion frame (3) down, pull cover out of clip groove (arrows) and unhook on hooking tabs | Injury hazard! Retaining clips (4) have sharp edges Installation: Install retaining clips | |
4 | Remove cushion frame (3) from foam rubber pad (5) | ||
5 | Loosen upholstery clips (6, 4 each) on lateral retaining strip (10) | ||
| Assembly hook for tacking tod | ||
6 | Remove foam rubber pad (5) from rubberized fiber matting (7) | ||
7 | Pull Velcro strips (11) off of rubberized fiber matting (7) all the way around, draw cover (2) over rubberized fiber matting (7) and fold in at side | ||
8 | Unhook upholstery clips (8) from longitudinal retaining wire (9) by turning upholstery clips (8, 12 each) 90° with flat pliers and remove | ||
| Installation tool for retaining wire | Use for installation | |
9 | Remove cover (2) from rubberized fiber matting (7) | ||
| Upholstery filling of seat modified | Installation: Valid only when fitting new seat covers or new rubberized fiber matting | |
10 | Pull longitudinal retaining wires (9, 4 each) out of fabric sleeves in cover (2) | Installation: Insert longitudinal retaining wires into fabric sleeves and align | |
11 | Reinstall in opposite order |