AR91.12-P-1720GI | Remove/install tilting rear seat | 3.5.99 |
MODEL 163.136 /154 /172 as of 1.9.99,
163.113 /128 /157 /174 /175
P91.12-2128-09
1 Cushion below arm rest
2 Bolts
7 Center seat belt
8 Seat belt bolt
9 Rear seat cushion
10 Belt end fitting
3 Covers
4 Bolts
5 Bolts
6 Backrest
| Remove, Install | ||
1 | Remove headrests | See Operating Instructions | |
2 | Remove rear cargo space floor flaps | See Operating Instructions | |
3 | Fold other bench down into the footwell | See Operating Instructions | |
4.1 | Remove cushion (1) from underneath arm rest | Applies to 60% seat bench only. Unscrew 2 bolts on the bottom of the rear side, and turn upholstery upwards, in order to detach locating tab at the rear. | |
5 | Remove screws (2) for covering (3) | ||
6 | Remove covers (3) from backrest fitting | ||
7 | Remove screws (4) on backrest fitting | 60 % bench: Fold backrest down, in order to gain access to the screws on inside of the backrest fitting. | |
Torx bit set | |||
| |||
8 | Fold bench seat into footwell | Rear seat backrest remains erect. | |
9 | Remove screw (5) on backrest bracket | Pull handle forward. | |
Torx bit set | |||
| |||
10 | Remove rear seat backrest (6) from bench | Put rear seat backrest down in the load compartment. | |
11.1 | Detach seat upholstery from back of rear seat cushion (9) | Applies to 60% seat bench only. | |
12.1 | Carefully lift seat upholstery upwards and remove seat belt screw (8) on belt end fitting (10) on the rear seat bench frame | Take care not to damage seat upholstery. | |
Applies to 60% seat bench only. | |||
Torx bit set | |||
| |||
13.1 | Remove buckle connector from seat frame and withdraw from retaining clamp | Only 60 % bench seat in combination with rear side airbag (left and right), code 293. In order to avoid fault codes, turn ignition key to the "0" position. | |
14.1 | Remove belt end fitting (10) together with buckle through the rear seat cushion (9) | Do not damage seat cover! | |
Applies to 60% seat bench only. | |||
15 | Install in the reverse order |
Rear seats
Number | Designation | Model 163 as of 09/99 | |
BA91.12-P-1006-03A | Bolt for backrest fitting to rear seat backrest | Nm | 30 |
Seat belts/belt tensioners
Number | Designation | Model 163 up to 08/99 | Model 163 as of 09/99 | |
BA91.40-P-1001-01D | Screw on belt end fitting | Nm | 35 | 35 |
Torx bit set
000 589 01 10 00