Remove/install rear bumper

AR88.20-P-2200P

Remove/install rear bumper

4.11.09

16.2.00

Value changed from 20 Nm to 6 Nm

Value modified in BA88.20-P-1002-02A Model 203

*BA88.20-P-1002-01A



Removing

1

Remove trim in trunk

 Left and right side wall paneling and trunk floor paneling.

AR68.30-P-4600P

2.1

Disconnect PTS, rear bumper connector (X35/28)

With code 220a (Parktronic system).

3

Remove clips (2) from inner fender and rear bumper

4

Unscrew bolt (3)

 Left and right side

5

Unscrew screw from rear exhaust mount

6.1

Unscrew nuts (4, 11) and screw (5)

 Without code 550 (trailer hitch)

 Left and right side

6.2

Loosen nuts (6) on adjustment screw (10)

 With code 550 (trailer hitch).

 Left and right side

7

Remove bumper (1)



Install

8

Convert M-AMG bumper

 Refer to installation instructions for accessories.



Retrofit AMG trim parts

AZ88.00-P-0001L

9.1

Install bumper (1)

 Without code 550 (trailer hitch).

 When installing ensure that mount (7) are moved into guides (8) on left and right.

9.2

Install bumper (1)

 With code 550 (trailer hitch).

 When installing ensure that mount (7) are moved into guides (8) on left and right.

Move adjustment screws (10) into retaining sheet metal plates.

10

Screw in bolts (3)

 Move bumper until edge of bumper (1) is flush with edge of rear fender.

 Check bumper gaps (1), correct if necessary.

 Left and right side

*BE88.20-P-1002-01A



*129589032100

11.1

Screw in nut (4) and screw (5)

 Without code 550 (trailer hitch).

 Left and right side



*BA88.20-P-1005-01A



*BA88.20-P-1009-01A

11.2

Screw in nuts (11)

 Without code 550 (trailer hitch).

 Left and right side



*BA88.20-P-1002-01A

12.1

Position nuts (6) and tighten

 With code 550 (trailer hitch).

Tighten nuts (6) only to point that it is possible to turn the adjustment bolts (10).

Adjust uniform gap on bumper (1) with adjustment bolts (10).

13

Screw screw into rear exhaust mount

14

Press in clips (2)

15

Connect rear bumper PTS connector (X35/28)

 With code 220a (Parktronic system).

16

Install paneling in trunk

 Left and right side wall paneling and trunk floor paneling.

AR68.30-P-4600P

Number

Designation

Model 203

BE88.20-P-1002-01A

Di-men-sion

Rear bumper, gap dimension "B"

mm

6

See picture

AR88.20-P-2200E

Number

Designation

Model 203

BA88.20-P-1002-01A

Nut of rear bumper to rear center section

Nm

6

BA88.20-P-1005-01A

Bolt with seal washer of rear bumper to side fender

Nm

8

BA88.20-P-1009-01A

Screw for bumper on side wall in area of taillamp

Nm

6