P88.20-2568-09
1 Front bumper
2 Bolts
3 Bolt
4 Terminal strip
5 Bolt
6 Bolts
E5/1 Left fog lamp
E5/2 Right fog lamp
X26/27 Front PTS separation point
(with code (220a) Parktronic system (PTS))
7 Electrical connector
8 Mount
B14 Outside temperature display temperature sensor
P88.20-2569-07
Shown on left side of front bumper
5 Bolt
9 Shoulder
11 Engine hood
10 Adjusting nut
Modification notes
| Remove | ||
1 | Open engine hood (11) | See Operating Instructions | |
2 | Remove front fender liner section from left and right front fender | ||
3 | Unscrew bolts (2) | ||
4 | Loosen bolt (3), slide terminal strip (4) toward front and remove | Remove terminal strip (4) from left and right fender. | |
5.1 | Disconnect front PTS separation point (X26/27) | On vehicles with code (220a) Parktronic system (PTS) | |
6 | Disconnect electrical connector (7) from left fog lamp (E5/1) and right fog lamp (E5/2) | ||
7 | Unclip outside temperature display temperature sensor (B14) from front bumper (1) | ||
8 | Unscrew bolts (5) | ||
9 | Remove bolts (6) | ||
10 | Remove front bumper (1) toward front with aid of helper | Carefully remove front bumper (1) with aid of helper to prevent paint damage on left and right fender and on front bumper (1) | |
| Install | ||
11 | Insert front bumper (1) into left and right mount (8) at side | Carefully remove front bumper (1) with aid of helper to prevent paint damage on left and right fender and on front bumper (1) | |
12 | Screw in bolts (6) | ||
13 | Clip outside temperature display temperature sensor (B14) into front bumper (1). | ||
14 | Connect electrical connector (7) to left fog lamp (E5/1) and right fog lamp (E5/2) | ||
15.1 | Connect front PTS separation point (X26/27) | On vehicles with code (220a) Parktronic system (PTS) | |
16 | Screw in bolts (2) | ||
17 | Install terminal strip (4) on left and right front fender and tighten bolts (3). | ||
18 | Screw in bolts (5) | Screw in bolts (5) so that left and right stay (9) can still be moved | |
19 | Adjust transition (arrow A) between stay (9) and engine hood (11) with adjustment nut (10) | The stay (9) and the closed engine hood (11) should have the same height on the transition (arrow A). | |
20 | Align stay (9) between front headlamps and tighten bolt (5). | The gaps (arrows) between the front headlamp and the stay (9) should have the same width. Adjust stays (9) at both front headlamps | |
| |||
21 | Close engine hood (11) | See Operating Instructions | |
22 | Correct adjustment of left fog lamp (E5/1) and right fog lamp (E5/2), adjust if necessary | ||
| Check and correct headlamp adjustment |
Feeler gauge
129 589 03 21 00
Odkazované dokumenty
- ap8210p8260t Zkontrolovat, seřídit nastavení světlometů
- ar8810p1310t