P88.00-2340-09
Shown on model 451.3/4 up to 19.3.12
1 Front CBS
2 Screw
3 Fender cover
6 Screw
7 Screw
4 Expansion clip
5 Edge guard (up to 30.8.10)
P88.00-2341-09
1 Front CBS
8 longitudinal member panel
10 Screw
9 Expansion clip
P88.00-2500-06
Shown on model 451.3/4 as of 20.3.12
1 Front CBS
11 Screw
12 Catch
| Remove/install | ||
1 | Remove antenna rod | ||
2 | Remove additional turn signal lamps | ||
3 | Remove expansion clips (4) on left and right fender cover (3) | Open left and right door. On vehicles up to 30.8.10 press edge guard (5) to side in area of left and right fender cover (3). | |
4 | Slightly slide left and right fender covering (3) upward and remove. | ||
5 | Unscrew bolts (6, 7) | Installation: Check whether guide sleeve on bolt (7) is seated correctly. | |
6 | Unscrew bolts (2) from front CBS (1). | ||
7 | Remove longitudinal member panel (8). | ||
8 | Remove expansion clip (9) in area of left and right door hinge. | ||
9 | Unscrew bolts (10) located behind left and right longitudinal member panel (8) from front CBS (1). | ||
10 | Unscrew bolts (11) from front CBS (1). | ||
11 | Loosen catches (12) on CBS front end (1) and remove CBS front end (1) with aid of helper. | With code (V07) Front fog lamp (FFO), with code (V12) LED-daytime running lights or daytime running lights "straight design", it is necessary to disconnect electrical connectors from front fog lamps and daytime running lights. | |
12 | Install in the reverse order |