AR86.10-P-0102MBA | Remove/install fire extinguishing system temperature sensor | 25.8.04 |
MODEL 220.1 /8 up to 14.4.04
with CODE (Z04) Light armoring
with CODE (Z07) Top protection
with fire extinguishing system,
fire extinguishing system motor temperature sensor
P86.10-2072-06
Shown on model 220.1
B65 Engine fire extinguishing system temperature sensor
B65x1 Engine fire extinguishing system temperature sensor connector
| Remove/Install | ||
| Danger of actuating fire extinguishing system when the work sequence is not observed. | ||
1 | Ignition Off, detach transmitter key from the electronic ignition switch control unit | ||
2 | Remove fuses no. 54 and no. 58 from rear fuse and relay module | The rear fuse and relay module is located below the right rear seat See | |
| Fuse assignment of rear fuse and relay box | ||
3 | Open engine hood | See Operator's Manual | |
4.1 | Disconnect engine fire extinguishing system temperature sensor connector (B65x1) from engine fire extinguishing system temperature sensor (B65) | When removing fire extinguishing system temperature sensor (B65) at top of left spring strut tower | |
Installation: Ensure that the fire extinguishing system temperature sensor connector (B65x1) is free of moisture and dirtThe insulating tubing of the connection line should be seated correctly in the plug housing; if necessary, fasten insulating tubingDanger of erroneous actuation. | |||
5.1 | Unscrew counternut and remove fire extinguishing system temperature sensor (B65) at top on spring strut tower | When removing fire extinguishing system temperature sensor (B65) at top on left spring strut tower | |
Installation: Ensure that the marking (red dot) on the fire extinguishing system temperature sensor (B65) points upward following installation | |||
Danger! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | |
6.1 | Raise vehicle. | When removing fire extinguishing system temperature sensor (B65) at bottom left on front wheel carrier | |
Do not damage extinguishing agent lines on fire extinguishing system when jacking up vehicle. | |||
7.1 | Disconnect engine fire extinguishing system temperature sensor connector (B65x1) from engine fire extinguishing system temperature sensor (B65) | When removing fire extinguishing system temperature sensor (B65) at bottom left on front wheel carrier. | |
Installation: Ensure that the fire extinguishing system temperature sensor connector (B65x1) is free of moisture and dirtThe grommet of the connection line should be seated properly in the connector housing, if necessary fasten grommet. Danger of erroneous actuation. | |||
8.1 | Unscrew counternut and remove fire extinguishing system temperature sensor (B65) at bottom left on front wheel carrier | When removing fire extinguishing system temperature sensor (B65) at bottom left on front wheel carrier | |
Installation: Ensure that the marking (red dot) on the fire extinguishing system temperature sensor (B65) points downward after installation | |||
9 | Install in the reverse order | ||
10 | Perform self-test for fire extinguishing system |
Odkazované dokumenty
- ar8610p010101mb
- as0000z001001a Nebezpečí ohrožení života v případě sesunutí nebo překlopení vozu z dílenského zvedáku
- gf5415p125601mb