ar8370d5302b

Removing and installing auxiliary heater

Typ ar · téma 83.70 · verze 0104 · 1998-07-31

Platí pro: MODEL 901.06#, 902.06# /07#, 903.06# /07#, 904.06# ## up to 753730 up to 31.10.97 with CODE (H11) Hot air auxiliary heater Heater designation B3L-C

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 3 Nástavba › 83 Klimatizace › 83.70 Nezávislé topení, přídavné topení, přihřívač — Řada 901 (modely 06*) · Řada 902 (modely 06*, 07*) · Řada 903 (modely 06*, 07*) · Řada 904 (modely 06*)

EinPAS 39 Topení/větrání/chlazení › 39.25 Nezávislé topení/přídavné topení › 39.25.30 Topné zařízení — Řada 901 (modely 06*) · Řada 902 (modely 06*, 07*) · Řada 903 (modely 06*, 07*) · Řada 904 (modely 06*)

AR83.70-D-5302B

Removing and installing auxiliary heater

4.11.96

MODEL 901.06#, 902.06# /07#, 903.06# /07#, 904.06# ## up to 753730 up to 31.10.97 with CODE (H11) Hot air auxiliary heater
Heater designation B3L-C

Removing and installing auxiliary heater

D83.70-0024-06

1 Mounting clamp
2 Hot air hose
3 Mounting clamp
4 Fresh air hose
5 Mounting clamp
6 Fuel line
7 Hex. head bolt
8 Hex. head bolt
9 Electrical connector
10 Electrical connector
11 Cable strap
12 Heater

Removal, installation

Danger!

Fuel vapors present an explosion hazard. Combustion gases are toxic when inhaled. Heater can cause severe burns during and after operation

Do not start up or operate stationary heaters or engines with heater boosters in closed rooms or in the vicinity of service stations. Allow heater to cool off after operation and wear protective gloves.

AS83.70-Z-0002-01A

1

Loosen mounting clamp (1) and pull off hot air hose (2)

2

Loosen mounting clamp (3) and pull off fresh air hose (4)

Danger!

Fuel vapors present an explosion hazard. Fuel vapors are toxic when inhaled or absorbed. Contact with fuel can cause eye and skin injury.

Fire, open lights and smoking prohibited.
Fill and store fuel only in containers intended for this purpose and marked accordingly.

Wear protective clothing when handling fuel.

AS47.00-Z-0001-01A

3

Loosen hose clamp (5) and pull off fuel
line (6)

Catch fuel running out.

Location of fuel metering pump changed to eliminate formation of vapor bubbles

If the fuel metering pump is fastened to the bottom of the heater, reconvert by refastening to front of heater.

BT83.70-D-0001-01A

4

Support heater (12)

5

Unscrew hex. head bolts (7, 8) on both sides

6

Lower heater (12) until electrical connectors (9, 10) are accessible

7

Remove cable strap (11)

8

Disconnect electrical connectors (9, 10)

9

Lift heater (12) out

10

Install in opposite order

Odkazované dokumenty