P82.10-3543-11
1 Disconnect plug from headlamp.
2 Twist ignition module plug (arrow) to the left and detach.
P82.10-3544-06
3 Put ignition module plug aside.
4 Remove retaining collar at burner.
Dispose of retaining collar.
5 Remove burner.
Do not touch the glass of the bulbs with bare fingers. Use a soft cloth free of grease and pay attention to correct installation position. Otherwise, the deposits that develop can reduce the light output of the reflector.
6 Cut off ignition module plug as close to the ignition module as possible.
Dispose of ignition module plug.
P82.10-3545-11
7 Cut off the three supply lines (red, black and green) as close to the ignition module as possible.
This shuts downs the ignition module in the headlamp.
P82.10-3546-11
8 Solder the adapter cable onto the supply lines
Be careful not the damage the headlamp housing with the hot air gun.
9 Wrap solder connector with fabric tape.
P82.10-3547-11
10 Remove the four catch lugs (arrows) in the retaining collar.
P82.10-3548-11
11 Insert burner and attach with retaining collar. Route the ground contact to the bottom.
Do not touch the glass of the bulbs with bare fingers. Use a clean soft cloth and pay attention to correct installation position. Otherwise, the deposits that develop can reduce the light output of the reflector.
P82.10-3549-05
12 Mount new ignition module and latch.
Note installation position: right xenon headlamp ignition module (A) and left xenon headlamp ignition module (B).
13 Insert plug into ignition module.
14 Insert plug into headlamp.