P72.18-2017-09
1 Door paneling
2 Guide sleeve
3 Bolt
7 Seal
8 Bracket
9 Catch
4 Shaft molding
5 Front CBS
6 Washer
| Remove/install | ||
1 | Remove outside mirror | ||
2 | Remove outside door handle on front door | ||
3 | Mask front CBS (5) in area of door with suitable masking tape. | ||
4 | Remove shaft molding (4). | ||
5 | Unscrew bolt (3) from door paneling (1) and remove with guide sleeve (2). | ||
6 | Open door, carefully slide door paneling (1) toward rear and lift over door panel lining in rear area (arrow A). | Handle door paneling (1) carefully to prevent scratching and breakage | |
Installation: Do not damage seal (7) on window (6), otherwise window (6) must be replaced. | |||
Installation: Seal (7) on window (6) should run over shaft molding (4). | |||
7 | Carefully slide door paneling (1) toward front until brackets (8) are exposed in their guide in the door body shell. | ||
8 | Slightly lift door paneling (1) in the front and rear area of the shaft molding (4) and pull toward outside until catches (9) are released. | ||
9 | Carefully slide door paneling (1) toward front and remove downward. | Installation: Before installing door paneling (1), pull shaft molding (4) from rear onto door paneling (1). | |
10 | Install in the reverse order |