Remove/install sliding door

AR72.16-D-1260B

17.3.10

MODEL 901.06 /36 /37 /46 /66 /67, 902.06 /07 /36 /37 /46 /47 /66 /67, 903.06 /07 /36 /37 /46 /47 /66 /67, 904.06 /36 /46 /66

MODEL WD1, WD2, WD3, WD6, WD7, YD1, YD2, YD3, YD4, YD5, YD6, YD7

MODEL 690.63/ 64

D72.16-1210-09

1 Sliding door

2 Sliding door stop

3 Screw

4 Upper sliding door stop

5 Screw

11 Entrance paneling

12 Screw

13 Plug

14 Screw

15 End piece

6 Carriage

7 Screw

8 Lower sliding door stop

9 Screw

10 Plug

 	Remove/install
1	Remove handle strip of sliding door	On freezer vehicle or refrigerator vehicle, code ZA5 or ZA8	AR83.65-D-2270-01A
			*BR00.45-Z-1059-01A
2	Remove end piece (15)		*BA72.16-N-1008-01A
3	Remove sliding door stop (2)	 Installation: Replace bolt (3).
			*BA72.16-N-1009-01A
4.1	Remove additional sliding door stops (4, 8) at top and bottom from sliding door	With code ZB2 (scope of delivery Fedex) or ZS4 (scope of delivery UPS)  Installation: Replace bolts (5, 9).
			*BA72.16-N-1009-01A
5	Remove bottom carriage from sliding door.		*BA72.16-N-1004-01A
6	Push sliding door to the rear using the center and top carriages (arrows).
7	Remove plugs (10, 13) from the entrance paneling (11).
8	Remove bolts (12) and remove scuff plate
9	Remove carriage (6).	 Check for wear before installing bottom carriage, replace if necessary.
10	Install in the reverse order	 If the door is replaced, the seams must be sealed all around before painting
11.1	Adjust additional sliding door stops (4, 8) at top and bottom	With code ZB2 (scope of delivery Fedex) or ZS4 (scope of delivery UPS)  The center stop buffer should make contact with the C-pillar for adjustment. Adjust upper and lower stop buffer (4, 8) to a gap of 2 mm to C-pillar and tighten
			*BA72.16-N-1009-01A
12	Check the setting of the sliding door.	Adjust if necessary.	AR72.16-D-1023B

 Sliding doors

Number	Designation			Models 690.6, 901, 902, 903, 904	Models WD1/WD2/ WD3/WD6/ WD7/YD1/ YD2/YD3/ YD4/YD5/ YD6/YD7


BA72.16-N-1004-01A	Screw for bottom carriage on sliding door		Nm	25	25
BA72.16-N-1008-01A	Bolt, end piece to guide rail		Nm	10	10
BA72.16-N-1009-01A	Screw for sliding door stop on sliding door	8.8	Nm	10	10
		10.9	Nm	-	-

Repair materials

Number	Designation	Order number
BR00.45-Z-1059-01A	White sealant	A 004 989 34 20