Sliding doors
Number | Designation | Model | ||
BA72.16-N-1003-01A | Screw for guide wedge on sliding door | Nm | 10 | |
BA72.16-N-1009-01A | Screw, sliding door stop to sliding door | 8.8 | Nm | 10 |
10.9 | Nm | – | ||
BA72.16-N-1010-01A | Screw for sliding element on B-pillar | Nm | 10 | |
BA72.16-N-1014-01A | Screw for locking bolt on B-pillar | Nm | 25 | |
D72.16-0005-01
D72.16-0004-01
Adjust flatness in relation to B-pillar
1 Loosen hex. head screws (6, 7).
Adjust flatness by moving upper and lower carriage.
3 Tighten hex. head screws (6, 7) .
D72.16-0006-01
Adjust rear installation depth
4 Loosen Torx screws (8).
Move door eye horizontally and adjust rear installation depth.
Adjust rear installation depth until flush or with 1mm protrusion.
D72.16-0007-01
Adjust guide wedge.
Adjust the position of the guide wedge (9) in relation to the sliding element (10) by moving the guide wedge (arrows A, B).
Close sliding door.
This centers the guide wedges (9) at the sliding elements (10).
Check installation depth of sliding door in relation to B-pillar.
The installation depth must be adjusted so that the sliding doors are flush or protruding 1mm to the inside.
Tighten Torx screws (5).
D72.16-0008-01
Adjust sliding door stop.
11 Loosen sliding door stop (11).
Open sliding door and hold in end position.
Hold sliding door stop, position at C-pillar free of clearance and tighten.