AR72.10-W-2010-01A | Adjust installation depth of folding door | ||
Danger! | Risk of injury from pinching and crushing when working on the folding door and the folding door control system | When working on the folding door or folding door control, relieve pressure from system with emergency lever (off position). |
Modification notes
Check
1 Check installation depth of folding door in three positions
Test positions:
When the folding door is open, the folding front and rear door wing must be parallel over the entire length and a gap should not be present between the two door seals.
When the folding door is closed, the rear door seal must make uniform contact over the entire length with the seal on the door frame over the entire length.
When the folding door is closed, guide pin should run into guide piece in entrance.
Adjust
2 Loosen nut (1) on eccentric (2)
3 Loose nut (1) on guide pin (3).
4 Adjust eccentric (2).
5 Adjust guide bolt (3).
6 Screw nuts (1) tight.
7 Loosen counternut (4), adjust height of lower guide pin (3) by turning, tighten counternut (4).
Only if height of guide pin (3) must be adjusted.
W72.10-1062-03
Odkazované dokumenty
- as7200z000101a Nebezpečí poranění při přivření nebo přiskřípnutí během prací na skládacích dveřích nebo na ovládání skládacích dveří