ar7210p0500mcc

Remove/install front door

Typ ar · téma 72.10 · verze 0100 · 2006-12-14

Platí pro: MODEL 451.3/ 4

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 3 Nástavba › 72 Dveře › 72.10 Přední dveře — Řada 451 (modely 3**, 4**)

EinPAS 35 Karoserie/rám/montované díly › 35.35 Dveře › 35.35.40 Přední dveře — Řada 451 (modely 3**, 4**)

AR72.10-P-0500MCC

Remove/install front door

30.11.06

MODEL 451.3/ 4

Remove/install front door

P72.10-3376-05

Shown on right side of vehicle on model 451.3

1 Door

2 Front CBS

3 Bolts

4 Fuse

5 Retaining clip

X35/1 Left door separation point

X35/2 Right door separation point

Remove/install

Danger!

Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof.

Keep body parts and limbs well clear of moving parts.

AS00.00-Z-0011-01A

1

Remove service flap

2

Remove left and right longitudinal member paneling.

AR88.80-P-6000MCC

3

Partially loosen front CBS (2) to remove left and right door (1).

AR88.00-P-1010-04MCC

4

Mark installation position of left and right door (1) in area of door hinge on A-pillar.

5

Mark installation position of left and right door (1) in marked areas (arrows) in relation to body with adhesive tape.

6

Release retainer (4) and disconnect left door separation point (X35/1) or right door separation point (X35/2)

7

Loosen retaining clip (5) on A-pillar.

8

Unscrew bolts (3) of upper and lower door hinge on A-pillar, open door (1) and remove with aid of helper.

Installation: Open door (1) a number of times against stop after tightening bolts (3).Then close door (1) and retighten bolts (3).

Check door gaps (1); adjust if necessary:

Adjust front door

AR72.10-P-0550MCC

*BA72.10-P-1002-01H

9

Install in the reverse order

Front door

Number

Designation

Model 451.3/4

BA72.10-P-1002-01H

Screw for hinge on body

Nm

40

Odkazované dokumenty