Removing and installing roller blind motor

AR68.50-P-4800M

Removing and installing roller blind motor

1.10.01



Removing

Danger!

Risk of injury from jamming or bruises, in extreme cases from limbs being shorn off if limbs come into contact with mechanical parts.

No parts of the body or limbs should be within the operating range of the mechanism when moving components.

AS00.00-Z-0009-01A

1

Remove electric roller blind for

rear window (1)

AR68.50-P-4600M

2

Remove bracket (2)

 Drill out pop rivets (3).

3

Pull cable out of mounts

4

Unscrew screw (4) and pull drive disc (5) off of

drive (6) upward.

 The drive (6) should not be operated if it is not completely connected to the system.

5

Unscrew screws (7) and

remove drive (6) from electric

roller blind (1)



Installing

6

Install drive disc (5) on drive shaft (6)

 The splines of the shaft should engage in the drive disc.

7

Screw in screw (4)

 Always replace mounting screws.



*BA68.50-P-1003-01B

8

Screw drive (6) to electric roller blind (1)

 Do not tighten screws (7).

9

Connect power supply and completely extend electric roller blind

 Vehicle electrical system 11 to 14 V

10

Tighten screws (7)

 Electric roller blind in extended state.



*BA68.50-P-1002-01B

11

Check whether lever arms of electric roller blind move in uniformly

 If necessary loosen screws (7) and readjust drive.

Example: If the left lever arm moves in earlier, move drive to right.

Then retighten screws (7).

12

Press cable in mounts

13

Rivet mount (2) to electric roller blind (1)

 Hand riveter

*WH58.30-Z-1003-29A

14

Install electric roller blind for rear window

AR68.50-P-4600M

Number

Designation

Model
215, 220

BA68.50-P-1002-01B

Screw for drive

Nm

8,0

BA68.50-P-1003-01B

Screw for drive disc

Nm

4,5

Number

Designation

WH58.30-Z-1003-29A

Hand riveter