Remove/install paneling on D-pillar

AR68.30-P-4495T

Remove/install paneling on D-pillar

25.7.06

30.3.06

Removing and installing lower paneling on D-pillar replaced with removal and installation of load compartment inner paneling

Steps 3 and 14



Removing



Note on function reliability of windowbag

AH91.60-P-0693-01A

1

Unhook load compartment cover on both load compartment cover guide rails (4).

2

Remove paneling on left and right C-pillar

 Do not remove belt end fitting.

AR68.30-P-4490TA

3

Remove left and side load compartment inner paneling

AR68.30-P-1180T

4

Unscrew bolt (5).

5

Carefully unclip upper paneling (1) from clip (2) with mounting wedge



*110589035900

6

Push upper paneling (1) toward front out of load compartment cover guide rail (4) and pivot to side until electrical connector on left load compartment lamp (E15/8) and right load compartment lamp (E15/9) is accessible.

 Clips (3) remain on roof frame

7

Disconnect electrical connector from left load compartment lamp (E15/8) and right load compartment lamp (E15/9) and remove upper paneling (1).



Install

8

Remove clips (3) from roof frame and install in upper paneling (1).

 Replace damaged clips (3).



*WH58.30-Z-1004-19A

9

Connect electrical connector for left load compartment lamp (E15/8) and right load compartment lamp (E15/9) to corresponding wiring harness.

10

Insert upper paneling (1) into load compartment cover guide rail (4).

11

Clip upper paneling (1) to D-pillar

 Ensure that rear check strap of windowbag is routed correctly.Otherwise the window no longer functions properly

12

Tighten bolt (5)

13

Lift frame seal on rear-end door over upper paneling (1) with suitable tool.

14

Install left and right side load compartment inner paneling.

AR68.30-P-1180T

15

Install paneling on left and right C-pillar.

AR68.30-P-4490TA

16

Hook load compartment cover into both load compartment guide rails (4).

Number

Designation

WH58.30-Z-1004-19A

Door panel release lever