P63.50-3599-11
Shown on model 212
1 Scribe separation point on rear fender (1) (area O).
Transfer dimensions from vehicle.
2 Cut rear fender (1) at separation point (area O).
3 Remove section from rear fender (1).
P63.50-3600-08
Shown on model 212
4 Grind mating surfaces on rear fender (1) down to bare metal in the crosshatched areas.
Grind spot weld flanges down to bare metal on both sides.
5 Coat insides of spot welding flange on rear fender (1) with zinc dust paint.
Following steps 6, 7, 8 are not required when replacing C-pillar.
6 Cut out spot welds on lock striker bracket (2) (area P).
7 Drill through spot welds on lock striker bracket (2) (area P1).
8 Remove locking eye bracket (2).