P63.10-4978-06
1 Scribe separation point on inner C-pillar (2) an cut (area J).
Transfer separation point from vehicle.
2 Cut out spot welds and laser seam connection at rear shelf reinforcement of inner C/pillar (2) (areas H, I and K).
Cut out spot weld (area K) from inside.
3 Remove rear shelf reinforcement.
P63.10-4979-08
4 Grind mating surfaces on outer C-pillar (1), inner C-pillar (2) and reinforcement (3) down to bare metal in crosshatched areas.
Grind spot weld flanges down to bare metal on both sides.
5 Coat insides of spot weld flange on outer C-pillar (1), inner C-pillar (2) and reinforcement (3) with zinc dust paint.
To prevent adhesion problems, do not coat bonding surfaces with zinc dust paint (area L).
Observe pretreatment of bonding surfaces (area L).
P63.10-4980-03