W49.10-1134-09
1 | Heat shield | 4 | Nozzle unit | 7 | Clip | ||
2 | Bracket | 5 | Exhaust pipe | 8 | Clip | ||
3 | Coolant lines | 6 | Bracket | 9 | Turbine wheel housing |
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Topical note | Notes on self-locking nuts and bolts | ||
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
| Remove/install | ||
1 | Disconnect ground line of battery | See information from body manufacturer. | |
2 | Remove air intake hose at ATL | Clamp, air intake hose to turbocharger | |
3 | Remove heat shield (1) | Screw/bolt, heat shield to exhaust gas turbocharger | |
Screw/bolt, heat shield to turbine wheel/transmission housing | |||
4 | Remove bracket (2) of coolant lines (3) | Only for engine version Euro VI Standard | |
5 | Remove nozzle unit (4) on exhaust pipe (5) | Only for engine version Euro VI Standard | |
Do not disconnect coolant lines (3) and fuel line on the nozzle unit (4). | |||
Bolt, housing upper section to housing lower section for nozzle unit | |||
6 | Remove bracket (6) at exhaust pipe (5) and release at timing case | Bolt, bracket to exhaust pipe | |
Bolt, exhaust pipe bracket to timing case | |||
7 | Remove clamp (7) | Installation: Replace clamp (7) and sealing ring on exhaust pipe (5). | |
Bolt, exhaust flex pipe clamp to exhaust pipe | |||
8 | Remove clamp (8) | Installation: Replace clamp (8). | |
Screw/bolt, exhaust flex pipe clamp to exhaust pipe downstream of turbine wheel housing | |||
9 | Remove exhaust pipe (5) | ||
10 | Clean sealing surfaces on exhaust pipe (5) and turbine wheel housing (9) | ||
11 | Install in the reverse order | ||
12 | Start engine and perform an engine test run | Allow engine to run at a higher rotational speed. | |
13 | Check area of exhaust pipe (5) for leaktightness and switch off engine | Visual inspection. |
Odkazované dokumenty
- ah0000n000101a Upozornění k samopojistným šroubům a maticím
- ah0000n500001h Upozornění k zamezení poškozením kvůli znečistění a výskytu cizích těles
- as0000z000201a Nebezpečí poranění kůže nebo očí při zacházení s horkými nebo žhavými předměty
- as0000z000501a Nebezpečí úrazu při samovolném rozjetí vozidla při běžícím motoru. Nebezpečí poranění pohmožděním a popálením při výkonech prováděných během startování nebo při běžícím motoru