Shown before the modification |
1 | Screw |
2 | Cable tie |
3 | Elbow fitting |
4 | Noise damper |
G42.60-3162-81
Installation of new noise dampers |
5 | Fitting |
6 | Elbow fitting |
7 | O-ring |
8 | Noise damper |
G42.60-3163-71
G42.60-3164-71
G42.60-3167-78
Shown after the modification |
6 | Elbow fitting | 9 | Union nut | 11 | Electrical line | ||
8 | Noise damper | 10 | Compressed-air line | 12 | Cable tie |
| Remove | ||
1 | Unscrew screw/bolt (1) | The bolt (1) is no longer used. | |
2 | Remove cable ties (2) | ||
3 | Remove elbow fitting (3) with noise damper (4) | The elbow fitting (3), noise damper (4) and bracket are no longer used. | |
| Install | ||
4 | Attach fitting (5) to elbow fitting (6) | Use parts kit QAP3031405. | |
Fitting, noise damper to elbow fitting | |||
5 | Mount O-ring (7) on fitting (5) | Remove the O-ring (7) from the noise damper (8). Coat the O-ring (7) with synthetic grease. | |
Synthetic grease 50 g | |||
6 | Mount noise damper (8) on fitting (5) | The noise damper (8) is pressed onto the fitting only. The retaining ring must be attached to the noise damper (8) during the pressing-on operation. | |
7 | Loosen union nut (9) of compressed air line (10) | ||
8 | Swing compressed air line (10) upward (arrow) and tighten union nut (9) | ||
9 | Install elbow fitting (6) with noise damper (8) | Make sure that there is enough free space at the noise damper (8). | |
10.1 | Secure compressed air line (10) and electrical line (11) to noise damper (8) using cable tie (12) | With CODE (B76) Heated air drier | |
Route the compressed air line (10) and electrical line (11) so that they do not chafe against other components. The compressed air line (10) must not be kinked. | |||
10.2 | Secure compressed air line (10) to noise damper (8) using cable tie (12) | Except CODE (B76) Heated air drier | |
Route the compressed air line (10) so that it does not chafe against other components. The compressed air line (10) must not be kinked. |