Remove/install parking brake pedal assembly

AR42.20-P-0510GH

Remove/install parking brake pedal assembly

13.1.10

11.12.02

Notes on safety for lifting platform, included for the first time

AS00.00-Z-0010-01A

11.12.02

Check version of pedal assembly, included for the first time

Step 9

BT42.20-P-0510-01A

 

Remove/Install

Danger!

Lethal injuries are possible if vehicle slips off of lifting platform

Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

1

Pre-tension automatic cable slack adjuster

AR42.20-P-0520-01A

2

Remove cover of pedal assembly (71)

3

Remove parking brake indicator switch (S12).

4

Detach brake cable (85) from tensioning shackle at parking brake pedal (75) and unclip from holding lug using snap-release tool (043)

 Installation: Observe rubber ring (85c).

Snap-release tool

*129589116300

5

Remove pedal assembly (71).

Unscrew upper bolt (72) to do this.Only loosen lower bolt (72) and detach pedal assembly (71)

 Do not loosen torx bolts on back of pedal assembly (71) otherwise the pedal assembly (71) will be damaged beyond repair.



*BA42.20-P-1001-01A



Friction brake of parking brake pedal assembly, function

GF42.20-P-1000A

6

Detach control cable (79) for releasing parking brake.

 To do so, first remove the bracket (77a) and then detach the control cable (79) from the release lever (77). Unclip control cable (79) from pedal assembly (71) using tool (010).



Tool for releasing parking brake control cable

WF58.50-P-4220-01A

7

Install in the reverse order

8

Relieve load on automatic slack adjuster.

AR42.20-P-0520-02A



Inspecting

9

Check version of pedal assembly (71)



Parking brake pedal assembly modified

BT42.20-P-0510-01A

10

Adjust parking brake

AR42.20-P-0540GH

Number

Designation

Model 163

BA42.20-P-1001-01A

Bolt of pedal assembly, foot-operated parking brake, on front wall pillar

Nm

12