AR42.10-T-0200BA | Remove/install thrust pieces with boots when brake caliper is installed | 23.7.07 |
MODEL NMB613.358 /388 with REAR AXLE 746.217
W42.10-1087-11
1 Adjuster
2 Inner seal cap
3 Threaded tube
4 Bearing bushing
5 Thrust piece with CV boot
| Removing | ||
1 | Remove wheel | ||
2 | Remove brake pads | ||
3 | Insert new brake pad into outer brake anchor shaft. | The brake pad limits the range of adjustment of the thrust pieces and thus prevents the threaded tubes (3) from unscrewing completely which would mean that the brake caliper would have to be replaced. | |
4 | Adjust brake adjuster clockwise | Until the thrust pieces with boots (5) are accessible. Use only a box wrench or socket wrench for adjusting. | |
5 | Remove thrust pieces with bellows (5) | Further dismantling or opening of the brake caliper is not permitted. | |
for prying the thrust piece off the threaded tube | |||
6 | Remove bearing bushing (4) from studs of threaded pipes (3) | ||
7 | Check inner seal cap (2) | In case of any damage: | |
Replace brake calipers. | |||
8 | Check adjusting thread of threaded tubes (3) for corrosion | If water penetration or corrosion found: | |
Replace brake calipers. | |||
9 | Remove new brake pad from outer brake anchor shaft | ||
| Install | ||
10 | Coat the adjusting thread of the threaded tubes (3) with the specified grease. | Use only specified grease (white in color). | |
11 | Turn adjuster counterclockwise until threaded pipes (3) just about protrude from brake caliper housing. | ||
12 | Install new bearing bushing (4) on the studs of the threaded pipes (3) | ||
13 | Install thrust pieces with bellows (5) | ||
Press-in tool for installing thrust piece with boot (disk brake SB 5000, SB6000, SB7000) | |||
14 | Install brake linings | ||
15 | Fit wheel |
Auxiliary repair materials
Number | Designation | Order number |
BR00.45-Z-1021-06A | Assembly grease (white) | Knorr-Bremse AG |