Shown on rear axle
1 Adjustment screw
2 Automatic linkage adjuster
N42.10-2189-03
Adjust | |||
1 | Jack up vehicle at rear axle and place on axle stands | Perform when drum brake clearance is adjusted at the rear axle. | |
2 | Raise/support vehicle at front axle | Perform when drum brake clearance is adjusted at the front axle. | |
3 | Turn adjustment screw (1) on automatic linkage adjuster (2) counterclockwise until the wheels can be turned freely | ||
4 | Screw in adjustment screw (1) until a resistance is noticeable | ||
5 | Loosen adjustment screw (1) through approx. 360° | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
6 | Start the engine and allow to run until the operating pressure of the air brake system is reached | ||
7 | Put a box wrench on adjustment screw (1) and operate the brake pedal until the adjustment screw (1) cannot be moved any more | If necessary repeat adjustment procedure. | |
8 | Lower vehicle at rear axle | Perform when the vehicle is raised at the rear axle. | |
9 | Lower vehicle at front axle | Perform when the vehicle is raised at the front axle. |
Test values for service brake
Odkazované dokumenty
- ar0060i100002b
- ar0060i100003b
- as0000z000501a Nebezpečí úrazu při samovolném rozjetí vozidla při běžícím motoru. Nebezpečí poranění pohmožděním a popálením při výkonech prováděných během startování nebo při běžícím motoru