Front axle brake caliper
Number | Designation | Model 690.6 | Models | Model 904 | Model 905 | ||
BA42.10-N-1002-10A | Bleed screw to brake caliper | M101 | Nm | 16 | 16 | 16 | 16 |
Rear axle brake caliper
Number | Designation | Model | Model | Model | |||
BA42.10-N-1003-12A | Bleed screw to brake caliper | M101 | Nm | 16 | 16 | 16 | |
Rear axle brake caliper
Number | Designation | Model | Model | |||
BA42.10-N-1003-12A | Bleed screw to brake caliper | M101 | Nm | 16 | 16 | |
D42.10-0044-05
1 First bleeder position right rear
2 Second bleeder position left front
3 Third bleeder position rear left
4 Fourth bleeder position right front
01 HHT (Hand-Held Tester) /
STAR DIAGNOSIS
Shown on model 901-903
D42.10-0014-01
1 Fix ALB controller at full-load position.
The ALB controller must be secured with Panduit tape or wire in the full-load position due to pressure peaks which interfere with the bleeding procedure.
D42.10-0015-01
2 Connect HHT / STAR DIAGNOSIS to diagnostic socket.
3 Select program for bleeding brakes.
D42.10-0017-01
4 Fit bleeder hose onto the bleeder valve specified by the HHT / STAR DIAGNOSIS and open bleeder valve.
5 Activate bleeding routine by pressing the Start button.
6 Depress brake pedal sharply.
7 Close bleeder valve.
8 Allow brake pedal to move back slowly.
9 Repeat procedure until clear brake fluid free of bubbles flows out of bleeder hose.
10 Close bleeder valve .
Observe level of brake fluid in reservoir and top uf in good time.
Fill in quantity of brake fluid required, use brake fluid in accordance with Specifications for Operating Fluids Sheet 331.0.
11 Continue bleeding operation at the other bleeding points in the same way.
12 Remove Panduit tape or wire at ALB controller.