Front axle brake caliper
Number | Designation | Model 690.6 | Model 904 | Model 905 | ||
BA42.10-N-1002-10A | Bleed screw to brake caliper | M101 | Nm | 16 | 16 | 16 |
Rear axle brake caliper
Number | Designation | Model | Model | Model | |||
BA42.10-N-1003-12A | Bleed screw to brake caliper | M101 | Nm | 16 | 16 | 16 | |
D42.10-0082-05
1 First bleeder position right front
2 Second bleeder position left front
3 Third bleeder position right rear
4 Fourth bleeder position left rear
Illustrated on model 904
D42.10-0014-01
1 Fix ALB controller at full-load position.
The ALB controller must be secured with Panduit tape or wire in the full-load position due to pressure peaks which interfere with the bleeding procedure.
D42.10-0017-01
A Bleed primary brake circuit
2 Start bleeding process at right front, then left front.
Fit bleeder hose onto the bleeder valve for this purpose and open bleeder valve.
3 Depress brake pedal sharply.
4 Close bleeder valve.
5 Allow brake pedal to move back slowly.
6 Repeat procedure until clear brake fluid free of bubbles flows out of bleeder hose.
7 Close bleeder valve .
Observe level of brake fluid in reservoir and top up in good time.
Fill in quantity of brake fluid required, use brake fluid in accordance with Specifications for Operating Fluids Sheet 331.0.
B Bleed secondary brake circuit
8 Start bleeding process at right rear, then left rear.
9 Continue bleeding operation as described in steps 2 through 7.
10 Remove Panduit tape or wire at ALB controller.