1 | Superior holder bolt of intermediate bearing (oblong) |
2 | Intermediate bearing side support |
3 | Side holder bolt of intermediate bearing |
4 | Side holder bolt of intermediate bearing (oblong) |
5 | Intermediary bearing |
6 | Coupling flange |
B41.10-A000-06
B41.10-A001-09
A | Installation distance of intermediate bearing holder | 7 | Intermediate bearing superior support | |
2 | Intermediate bearing side support |
| Remove | ||
1 | Remove the superior holder bolts of intermediate bearing (oblong) | Remove from both sides | |
2 | Remove the intermediate bearing superior support (7) | ||
3 | Remove the bolts from the intermediate bearing side supports (oblong) (3 and 4) | Remove from both sides | |
4 | Remove the intermediate bearing side supports (2) | ||
| Install | ||
5 | Install the intermediate bearing superior support (7) | ||
6 | Fasten the side supports (2) to the upper bearing of the intermediate bearing (7) without applying torque to the bolts (1, 3 and 4) | ||
7 | Adjust the installation distance (A) of intermediate bearing holder (7) | Installation distance of intermediate bearing holder | |
The distance (A) must be observed, otherwise; | |||
| |||
The drive shaft installed at the wrong angle causes damage and/or breakage. | |||
8 | Tighten the bolts (1 and 4) (oblong) | The intermediate bearing has to be 900 in relation to the drive shaft, for this adjustment there are oblongs in the drilling of the support. | |
.Side holder bolt of intermediate bearing | |||
.Superior holder bolt of intermediate bearing | |||
9 | Tighten the screws (3) | .Side holder bolt of intermediate bearing |