Front axle toe-in test values
Number | Designation | Model 613.364/ | ||
BE40.20-N-1002-07B | Toe-in (with front wheels spread apart) | Spreading force | Nm | 400 |
Total toe-in | mm | 0 (4) | ||
Track rod
Number | Designation | Model | |
BA46.40-N-1001-01F | Nut for clamp collar on tie rod | Nm | 75 |
Torque wrench
001 589 67 21 00
Commercially available tools
T46.40-0012-01
1 Move the steering linkage into the center position.
The steering gear pitman arm and steering idler arm must be parallel to the vehicle longitudinal axis
2 Press the wheels apart at the front using the spreader
Observe the specified spreading force.
3 Loosen the hose clamps (1) of the tie rod (2)
4 Adjust the toe-in of both wheels by turning the tie rod (2).
The divided tie rods mean that in must be ensured that the specified value of toe-in counts as the total value and consequently only half the value applies to each wheel as tolerance.
5 Tighten the hose clamps (1) of the tie rod (2) .
Use new nuts. Tighten the nuts only finger-tight first and carry out the final tightening with the torque wrench.
Shown on the right-hand side
Odkazované dokumenty
- ah0000n000101a Upozornění k samopojistným šroubům a maticím