ar4020p0321b

Adjusting ball point position

Typ ar · téma 40.20 · verze 0105 · 1998-05-04

Platí pro: MODEL 140, 170, 202, 208

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 2 Podvozek › 40 Kola, měření geometrie podvozku › 40.20 Měření geometrie podvozku — Řada 140 · Řada 170 · Řada 202 · Řada 208

EinPAS 20 Podvozek › 20.10 Měření podvozku › 20.10.20 Diagnostika/zkouška/proměření/nastavení — Řada 140 · Řada 170 · Řada 202 · Řada 208

AR40.20-P-0321B

Adjusting ball point position

20.5.94

MODEL 140, 170, 202, 208

Adjusting ball point position

Adjusting ball point position

Adjusting ball point position

P40.20-0214-01

P40.20-0216-01

P40.20-0215-01

1	Adjust ball point position by moving the steering idler arm (26) on the bearing tube.	If the ball point position cannot be adjusted at the steering idler arm, a correction to the ball point position can be made at the pitman arm by offsetting (a) on the splined section of the pitman arm shaft.	*BE40.20-P-1001-05A
			*BA40.20-P-1002-01A
		On vehicles involved in accidents or suspected of being involved in accidents, ensure basic setting dimension between the bearing tube and steering idler arm.	ra46001246317x
		If the ball point position is more than 5 mm outside the tolerance, check the steering idler arm bearing .
		Model 140	AR40.30-P-0450A
		Model170, 202, 208

Ball point position

Number	Designation		Model 140	Model 170	Model 202	Model 140 special protection	Model 208


BE40.20-P-1001-05A	Ball point position	mm	102	30.52	312	12	312

 Chassis alignment check

Number	Designation		Model 140	Model 202	Model 170	Model 208


BA40.20-P-1002-01A	Steering idler arm to bearing bush	Nm	35	30	30	30

Odkazované dokumenty