Perform chassis alignment check

AR40.20-P-0200GC

Perform chassis alignment check

7.10.96



Measuring, adjusting

Danger!

Risk of death cased by vehicle slipping or toppling off of the lifting platform.

Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

1

Drive the vehicle into the alignment check bay and apply the parking brake

The measuring system must be approved by Mercedes-Benz.

Observe general information on chassis alignment

AR40.20-P-0201GC

2

Using the adapter, install the brake pedal retaining tool between the pedal and the driver's seat

 Protect the brake pedal and driver seat from damage.

Brake pedal jack

*000589183100

 Adapter for brake pedal winch

*211589003100

3

Attach rapid-clamping devices

AR40.20-P-0230GC

4

Unlock turnplates and sliding platforms

5

Position the probes and align them horizontally

 To avoid possible damage, ensure that the probes will continue to have adequate ground clearance when the steering is turned to full lock.

6

Perform initial measurement

7

Use the electronic inclinometer to check the vehicle's ride height at the front and rear axles and adjust as indicated

Model 168

AR40.20-P-0301GC

Model 414

AR40.20-L-0301VA

8.1

Check and adjust camber and caster at front axle

According to results of initial measurement.

Model 168

AR40.20-P-0322GC

Model 414

AR40.20-L-0322VA

9.1

Check and adjust front axle toe

According to results of initial measurement.

Model 168

AR40.20-P-0323GC

Model 414

AR40.20-L-0323VA

10.1

Checking rear axle toe angle

According to results of initial measurement.

AR40.20-P-0333GC

11

Perform final measurement

12

Detach sensors

13

Remove brake pedal jack tool with its adapter

 Brake pedal winch

*000589183100

 Adapter for brake pedal winch

*211589003100

14

Drive vehicle off measuring system

15

Lock turntables and sliding platforms