Front tyre removal |
Y40.10-0001-06
Front tyre installation |
Y40.10-0002-06
Rear tyre removal and installation procedure |
3 | Outer tyre |
4 | Inner tyre |
Y40.10-0003-06
Front axle tyre rotation procedure |
A | Vehicle front |
LH | Left hand side |
RH | Right hand side |
Y40.10-0010-06
Front tyre removal procedure | |||
1 | Loosen wheel nuts. | Place jack under the front axle beneath the spring support. | |
2 | Pump jack until it supports front axle and the tyre is lift off the ground. | Completely loosen the nuts after lifting. | |
3 | Remove tyre from the vehicle carefully. | ||
Front tyre installation procedure | |||
4 | Place tyre on the hub. | Lift tyre to locate the stud holes. | |
5 | Fix all other wheel nuts and hand tighten. | Ensure that the nuts must be tightened in a diagonally face opposite pattern and an equal manner. | |
6 | Relieve load from the jack and remove it. | Tighten the wheel nuts after removing jack. | |
Front wheel nut tighten | |||
Rear tyre removal and installation procedure | |||
7 | Lift the jack until it butts the axle. | Place jack under spring support or between the spring bracket and differential housing. | |
Installation: Relieve load from the jack and remove it. | |||
8 | Loosen the wheel nuts. | Pump the jack to lift the tyre off the ground. | |
Installation: Ensure that the nuts must be tightened in a diagonally opposite pattern and an equal manner. | |||
Rear wheel nut tighten | |||
9 | Remove wheel nuts and remove the outer tyre (3) followed by the inner tyre (4). | Installation: Insert two nuts opposite same to another then hand tighten the nuts. | |
10 | Install in the reverse order. | ||
Tyre rotation procedure | |||
11 | Front axle tyres rotated in two different cycles. | Tyre rotation is a routine preventive maintenance practice to improve tyre life performance. | |
12 | Swap left hand (LH) and right hand (RH) sides assembly - (cycle 1). | ||
13 | Flip the tyres inside out for both left hand and right hand sides - (cycle 2). | Cycle 1 to be followed for every 10,000 km for increasing tyre life. | |
In case of uneven wear, tyre rotation to be carried out even before the kms indicating. | |||
If edge wear is visible on any specific tyre or both tyres, | |||
| |||
cycle 2 can be carried out. | |||
| Check | ||
14 | Check the wheels. |
Odkazované dokumenty
- ar4010y102503a Kontrola ráfku ohledně bočního házení