ar3550b0460a

Remove/install bracket for lift bellows of additional axle

Typ ar · téma 35.50 · verze 0100 · 2018-03-15

Platí pro: Model 979.096/098 with rear axle 749.117

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 2 Podvozek › 35 Zadní náprava › 35.50 Dodatečné nápravy (tlačené nápravy, vlečné, střední nápravy a nápravy přívěsu) — Řada 979 (modely 096, 098)

EinPAS 17 Hnací ústrojí/náprava › 17.52 Přídavná náprava › 17.52.52 Zařízení pro zvedání nápravy — Řada 979 (modely 096, 098)

Platí také pro motory/převodovky: 749 117

AR35.50-B-0460A

Remove/install bracket for lift bellows of additional axle

27.02.2018

Model

979.096/098 with rear axle 749.117

Remove/install bracket for lift bellows of additional axle

B32.20-0125-09

4

Auxiliary axle

10

Bracket for lift bellows

7

Regulation nuts

C

Adjusting measurement (with depressurized shaft)

9

Self-locking nuts

Topical note

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

Remove

1

Remove the brackets for lift bellows (10) self-locking nuts (9)


Do not move the adjusting nuts (7)
This position determination can help adjusting the height of the clips.

Check

2

Check the conditions of the brackets for lift bellows (10) and adjusting nuts (7)

Always replace the self-locking nuts (10).

In case the brackets for lift bellows (10) and the adjusting nuts (7) are in good conditions and are reused:

Do not move the adjusting nuts (7) as they will be the basis for adjusting the measure (C).

Install

3

Install the adjusting nuts (7) to the brackets for lift bellows (10)

If the components are new

4

Install the brackets for lift bellows (10) securing with adjusting nuts (9)

Do not apply the prescribed torque.

5

Adjust measure "C" between the brackets for lift bellows (10) and the auxiliary axle (4)

AR35.50-B-3593-01A

Adjustment measure between the bellows arch and the auxiliary shaft

*BE35.50-B-1001-04A

6

Apply the tightening torque to the fixing nuts (9)

Upper nut for locking the bellows arch

*BA35.50-B-1001-04A

Measurement of the clearance between the clamp and the auxiliary shaft

Number

Designation

Rear axle 749.117/118

BE35.50-B-1001-04A

Adjustment measure between the bellows arch and the auxiliary shaft

Vehicle empty without load

mm

20

Vehicle without body

mm

10

Fixture of the auxiliary shaft hanger

Number

Designation

Rear axle 749.117/118

BA35.50-B-1001-04A

Upper nut for locking the bellows arch

M22x1.5

Nm

260 ... 300

Odkazované dokumenty