AR35.30-P-0660-02I | Inner constant-velocity joint on rear halfshaft, extraction and pressing on | ||
| Shell halves (2 ea.) for pressing off and caulking the inner constant velocity joint. |
220 589 02 31 00
Clamping jaws
Drift
116 589 15 15 00
P35.30-2003-01
1 Measure and note distance (a) from end face of propeller shaft to constant velocity joint.
Distance (a) is usually approx. 4.0 mm to 4.3 mm.
P35.30-0213-01
Pressing off
2 Press off constant velocity joint using the shop-made shell halves (063a) and the drift (063).
3 Clean constant velocity joints.
P35.30-2006-01
Pressing on
4 Fit constant velocity joint on rear axle shaft so that the collar (arrow) points towards the center of the rear axle shaft.
P35.30-2004-01
5 Mount the clamping jaws (067) on the boot collar of the rear axle shaft (arrow).
P35.30-2005-02
6 Place rear axle shaft with clamping jaws (067) on the press.
7 Press on constant velocity joint all the way using drift (063).
P35.30-2003-01
8 Press on constant velocity joint using a suitable tube until the previously measured and noted distance (a) has been reached.
Dimension (a) is usually approx. 4.0 mm to 4.3 mm.